Prevue Hendryx FeatherStone Heights Cape Cod Bird Cage

Parts Included:1 steel base unit1 steel pull out tray1 wire grill flooring1 wire home body1 wire home roof1 chimney1 front door2 dormer windows2 feeding cup windows2 perches with end caps2 feeding cups4 assembly screwsAttach Wire Body Mesh to BaseAttach cage body mesh to base unit, by raising the horizontal wire lock on the side of the cage. This will allow the positioning wires to be inserted into the elongated holes in the base. Once the positioning wires are in place on one side, secure by lowering the wire lock to rest comfortably. Repeat this for the other side of the cage. When complete, the wire body should be secure with the base, fitting into the eight guide holes, with the locks on the right/left in the locked (down) position.Attach Wire Roof To Cage BodyLay wire roof assembly into position on top of the wire cage body. The top door of the roof will be positioned in the rear of the house. Secure roof to body by engaging all of the wire loops between the narrow spaced roof bars. Crimp with pliers for maximum security. Please use a cloth when crimping with pliers, to protect finish.Attach Chimney to CageAttach chimney to cage by locating the two screw holes in the side of the steel base unit, and temporarily lining them up with the holes in the bottom of the chimney. Attach the plastic chimney hook to the cage wire by rotating the chimney (do not force hook to pop between the wires). After chimney is in the correct position, secure with two screws provided.Attach Feeder Cup WindowsAttach windows (acting as feeder cup doors) by snapping them into the two wire openings on the front of the cage. When the feeding cups are in place, and the windows are in the closed position, the window will snug over the lip of the cup, creating a snug and secure fit.Attach Front DoorAttach front door by inserting the bottom of the door slightly into the cage, at an angle, and resting the two guide wires inside the cage. At this point the door will be resting comfortably in the open position. Close door by raising the drawbridge door unit and hooking the top wires.Attach Front Stairs to Metal DrawerAttach front stairs to holes in steel pull-out drawer using screws provided.Insert Grill Flooring, Dormer Windows & PerchesSlide the wire grill floor into position, so that it rests on the grill slide channels in the metal base unit. Attach end caps to perches and install. Rest dormer windows in desired position, placing the small hook on the inside top of the dormer into the wire of the roof, and allowing the bottom of the dormer to snug into one of the lower roof wires.