Prevue Hendryx FeatherStone Heights Stone Cottage Bird Cage

Parts Included:1 steel base unit1 steel pull out tray1 wire grill flooring1 wire home body1 wire roof (4 sided)1 wire roof (flat w/4 prongs)1 chimney1 front door2 stone corners (right)2 stone corners (left)2 feeding cup windows2 perches with end caps2 feeding cups4 assembly screwsAttach Wire Body Mesh to BaseAttach cage body mesh to base unit, by raising the horizontal wire lock on the side of the cage. This will allow the positioning wires to be inserted into the elongated holes in the base. Once the positioning wires are in place on one side, secure by lowering the wire lock to rest comfortably. Repeat this for the other side of the cage. When complete, the wire body should be secure with the base, fitting into the eight guide holes, with the locks on the right/left in the locked (down) position.Attach Stone Corner Units to Cage BodyUse the vertical tabs on the stone corner units to hug the double wires on the cage body. The other side of the corner unit is secured by pressing downward, and locking the L tabs into position. When secured properly, the corner unit will not move and will be further locked into position when the roof is attached. Please note that the position of the stone corner units are printed on the inside of each of the pieces (for example, "right rear" or "left rear").Attach Chimney to CageAttach chimney to cage by locating the two screw holes in the side of the steel base unit, and temporarily lining them up with the holes in the bottom of the chimney. Attach the plastic chimney hook to the cage wire by rotating the chimney (do not force hook to pop between the wires). After chimney is in the correct position, secure with two screws provided.Attach Wire Roof To Cage BodyOpen large wire roof assembly and position on top of cage body. Roof will overhang cage body, and clip over the second wire. Engage all of the wire latches. The top door of the roof will be positioned to the left. Then, after the body of the roof is secure, lay the flat roof top into position with the wire ends facing up. Secure by engaging all of the over/under wire latches. Crimp wire attachments with pliers for maximum security, using a cloth to protect painted finish from scratching.Attach Feeder Cup WindowsAttach windows (acting as feeder cup doors) by snapping them into the two wire openings on the front and side of the cage. When the feeding cups are in place, and the windows are in the closed position, the window will snug over the lip of the cup, creating a snug and secure fit.Attach Front DoorAttach front door by inserting the bottom of the door slightly into the cage, at an angle, and resting the two guide wires inside the cage. At this point the door will be resting comfortably in the open position. Close door by raising the drawbridge door unit and hooking the top wires.Assemble & Attach Top Decorative RailingAssemble top decorative railing by snapping the four railing units together to make a square. Press the hook of one unit into the receptor of the next, with the solid side of the railing balls facing outward. When complete, place on top of the cage and secure by inserting onto prong wires.Insert Grill Flooring, Front Stairs & PerchesSlide the wire grill floor into position, so it rests on the grill slide channels in the metal base unit. Attach end caps to perches and install where desired. Front stairs are attached to holes in pull-out drawer with screws.