SmartScoop Self-Scooping Cat Litter Box

Setting up SmartScoopLocate motor unit - turn clutch handle clockwise to the "unlocked" position.Align motor unit with litter pan edge, slide forward until leading edge is aligned with line on pan.Engage clutch by turning the lever counterclockwise to the "locked" position.Lift the plastic latch cover, and align waste unit vertically above motor unit, plush down lightly until waste unit aligns and latches engage (you will hear a "CLICK"). Make sure the waste unit and motor unit are fully engaged and there is no gap between them! Make sure that latch is engaged!Next, place the straight end of the litter rake into the hole in the waste unit. Then insert the curved end into the rake slot with the end pointing upward. NOTE: You will need to hold the rake safety door open to assembe the litter rake properly. When you release the rake safety door, it will spring closed.close the latch cover. The rake safety door should always be closedTo install the waste deflector, snap it into the groove located at the end of the litter box. The smooth side of the deflector should face the inside of the litter box.Locate AC power supply. Connect breakaway power supply cord to cord originating from motor unit.Fix power supply cord collar from motor unit into the slot located on the underside of the litter pan.Fill with clumping litter. Do not exceed the "Maximum" line indicated inside litter pan. Overfilling WILL damage the motor unit.Plug AC power supply into outlet.Press POWER button on motor unit to power-on SmartScoop (clutch lever must be rotated into "locked" position to turn on power). When SmartScoop is on, the MODE light will be solid green. Your litter box is now ready to go and will automatically complete a cleaning cycle 15 minutes after your at leaves the box.Mode Indicator Light; The mode indicator light shows the status of the SmartScoop:Green, solid: Unit is powered on and monitoring for cat activity.Green, blinking: Unit has detected a cat and is waiting 15 minutes to begin cleaning cycle.Red, solid: Unit has encountered excessive resistance. Turn off the unit, unlock the clutch, remove obstruction, slide waste unit back into "ready" position, lock clutch and turn it back on.Red, blinking: Last cleaning cycle failed to complete. Unit has detected a cat and is waiting 15 minutes to begin cleaning cycle.