Assembly:Place the Kabana unzipped half way with the seam side facing upward on a flat large surface. Seamside will be in the inside of the tent.Join two of the bent tubes together using one Long 2-Way connector. Make sure the tubes and connector are pushed in all the way.Place one Long 2-Way connector on each end marked "A" of the bent tubes. Make sure connector is inserted all the way.Repeat steps 2 and 3 with the remaining bent tubes and 2-Way connectors.Position assembled bent tubes parallel to each other with the opened connector ends facing upward.Join the 2 straight tubes together using the Short 2-Way connector. Make sure the tubes and connectors are pushed in all the way.Insert assembled straight tubes into center slot in the Kabana top.Both curved tubes and inside of the Kabana are marked with an "A" and "D". Starting from the outer edge of the Kabana insert curved tube.Using 3-Way connectors, connect the 4 curved tube ends marked "D" and the straight tubes ends together.Zip up the remaining KabanaPull the adapter cord through the vent flap.Care and CleaningCleaning: from time to time, wipe outer surfaces with a damp soft cloth. For more thorough cleaning, remove the LitterMaid litter box from the LitterMaid Kitty Kabana Litter Box Cover and hose down or wash with warm, soapy water. It may also be washed in a sink or tub.Do not place LitterMaid Kitty Kabana in washing machine or dryer. Allow Kabana to dry thoroughly before replacing it on frame.
LitterMaid Kitty Kabana