Roll Along Carrier Backpack

Assembly InstructionsYour Pet Wheel-Away is shipped to you in three parts.backpackbase platefront support barFind base plate and front support bar inside backpack.Lay the backpack on its back. Install base plate/wheel unit to bottom of backpack. With fabric side facing out, insert base plate's male tubes into female receptors.Press firmly into position. Attach loop material on bottom of backpack to hook material on edge of base place.Thread support bar through support pocket on front of backpack and secure with hook and loop material.Instructions For UseYour Pet Wheel-Away can function as a wheeled carrier, airline carry-on, backpack, pet bed, and car seat.Wheeled CarrierUnzip bottom or top mesh panel to place your pet inside. If needed, a safety hook is located inside the carrier. Clip safety hook to your pet's harness or collar. Push on the center release button to fully extend the telescoping handle.Tuck backpack straps into rear storage pocket when wheeling your pet in the wheeled carrier.BackpackPush the center release button to lower the telescopic handle. Remove the backpack straps from the rear storage pocket. Adjust the padded straps so backpack is comfortable to wear.Car SeatBe sure the telescopic handle is retracted and the backpack straps are stored in the rear pocket. Secure car seat in the back seat of the car by threading the shoulder/seat belt through the straps on the rear of the Wheel-Away.Important: Always secure your pet in the back seat of the vehicle to avoid injury from airbags.Airline TravelYour Pet Wheel-Away meets airline carry-on regulations and stows beneath the seat in front of you. To stow the Wheel-Away, slide the wheel base portion under the seat in front of you.Important: Always check with your airline before traveling with your pet.Pet BedYour Pet Wheel-Away can also be used as a bed. Simply unzip the top and bottom mesh panels and secure them to the center support. Lay the unit on its back.