The new QuickFinder Clipper is a nail clipper for dogs that utilizes QuickSensor Technology that senses your pet's quick and gives visual cues as to when it is safe and when it is not safe to begin clipping. Red-Yellow-Green. Green means Go! It is fast, safe and easy to use.Detects nail differences between the live blood of your pet's quick, and the dead skin of the nail and clawIncludes two AAA batteries
Instructions For Use:A complete list of important safety instructions is included with your purchase. Be sure to read and follow all safety precautions and keep instructions on hand for future reference. To power on the unit and keep powered up slightly squeeze handles together until red light only is illuminated (continue to keep handles slightly squeezed together to keep power on). If all lights illuminate and remain on, there is insufficient power and batteries must be replaced. If green light stays on, turn unit off by releasing handles, wait two seconds for unit to reset and restart power up phase again. Once red light stays illuminated unit has sufficient battery power and is ready for operation. With unit powered up (red light on), insert nail into fixed blade hole from under side of clipper. Keep nail at 90§ angle and against sensor side of the fixed blade hole. Move cutting blades toward base of nail far enough that quick in the nail will be detected for the first time. The red light will flicker and remain on. This sets the sensor to the quick in the nail. Note that the nail should continually be on the sensor side of the hole during sensing for sensing to occur. Maintaining power to unit, move cutting blades back towards nail tip away from nail base. The yellow light may briefly illuminate as blade and sensor approaches nail without quick. Continue moving cutting blades outward until green light illuminates indicating a safe cut. It is not safe to clip when yellow or red lights are on. While maintaining position and angle (90§) of clipper, squeeze handles together in firm swift motion to avoid crushing nail. It is normal for green light to turn off at end of clipping action after blade has cut through nail. If red light stays on, power off device and restart clipping process.
Miracle Coat QuickFinder for Small Dogs
Miracle Coat QuickFinder for Medium Dogs