Wahl Competition Series Detachable Blade Set #50

Replacement Blade Instructions2-Hole Clipper BladesOn adjustable clippers, push taper lever all the way up toward lid. Position small blade over clipper drive finger. Set large blade on top of small blade and partially tighten blade screws.Points of the small blade teeth should be 1/32" to 1/16" back from the large blade teeth.Far left tooth of small blade must be on top of or to the left of first small tooth of large blade.Far right tooth of small blade must touch big tooth on large blade. Tighten screws. Blades are aligned.3-Hole Adjusto-Lock Clipper BladesLoosen and remove the center screw only.Outside screws hold bushings in place and maintain alignment. Position smaller blade on clipper drive finger. Place large blade on top of small blade, fitting it down over the bushings on either side. Replace and tighten center screw. Keep screw tight after blades are aligned.Snap-On/Snap-Off Blade AssemblyTo remove blades, push blade assembly away from the front of clipper. Both blades will come off in one piece. To replace, reverse the process by seating bottom tab of blade assembly into notch provided on clipper. Push the top of the blade assembly toward clipper. When you hear a definite snap, the blades will be properly seated.Detachable Blade AssemblyTo remove blades, turn motor off. Push blade assembly away from clipper. Slide blade assembly off drive tongue. To replace blades, turn motor on. Place blade fully on drive tongue and snap into place.Apply clipper oil to blades while clipper is running.Made in the USA.Clipper Oil: Danger. Contains petroleum distillate. May be harmful or fatal if swallowed. Call physician immediately. Keep out of reach of children. Made in China.