UL listed.WARNING - To guard against injury, basic safety precautions should be observed including the following: 1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. 2. DANGER - To avoid possible electric shock, special care should be taken since water is employed in the use of aquarium equipment. For each of the following situations, do not attempt to repair yourself; return the appliance to an authorized service facility for service or discard the appliance. A. If the appliance falls into water, DON'T reach for it! First unplug it and then retrieve it. If the electrical components of the appliance get wet, unplug the appliance immediately. B. Carefully examine the appliance after installation. It should not be plugged in if there is water on the parts not intended to be wet. C. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or if it is dropped or damaged in any manner. D. To avoid the possibility of the appliance plug or receptacle getting wet, position aquarium stand and tank to one side of the wall mounted receptacle to prevent water from dripping onto the receptacle or plug. A "drip loop", shown in the figure below, should be arranged by the user for each cord connecting an aquarium appliance to the receptacle. The "drip loop" is the part of the cord below the level of the receptacle, or the connector if an extension cord is used, to prevent water travel along the cord and coming in contact with the receptacle. If the plug or the receptacle do get wet, DON'T unplug the cord. Disconnect the fuse to the circuit breaker that supplies power to the appliance. Then unplug and examine for the presence of water in the receptacle. 3. Close supervision is necessary when any appliance is used by or near children. 4. To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors, lamp bulbs, and etc. 5. Always unplug an appliance from the outlet when not in use, before putting on or taking off parts, and before cleaning. Never yank the cord to pull plug from the outlet. Grasp the plug and pull to disconnect. 6. Do not use an appliance for other than intended use. The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition. 7. Do not install or store the appliance where it will be exposed to the weather or to temperatures below freezing. 8. Make sure an appliance mounted on a tank is securely installed before operating it. 9. Read and observe all the important notices on the appliance. 10. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled. 11. This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do not attempt to defeat this safety feature. 12. This appliance is intended FOR HOUSEHOLD USE ONLY. Do not use or mount this appliance in such a way that the top vents are restricted or blocked. These vents are necessary to avoid over-heating and ensure safe operating temperature. 13. SAVE THESE INSTRUCTIONS CLEANING: It is important to keep this hood appliance clean. Unplug and remove the unit from the aquarium, using two hands as shown. Wipe exposed surfaces carefully with a damp terrycloth to remove any dust or mineral deposits which may collect over time. Make sure all surfaces are dry before reinstalling, using two hands. To prevent scratching the aquarium, use a damp terrycloth when cleaning. Never use algae scrapers, scouring pads, razor blades, glass cleaner or other such abrasives. To clean the divider, simply run under water and use a damp terrycloth if necessary. SERVICING: In order to assure proper electrical connections and polarity, replacement parts and servicing should be performed only by a qualified electrician. FILTER INSTALLATION: Set the unplugged MiniBow Filter onto the widened part of the frame inside the aquarium, hanging its cord over the back. Refer to the MiniBow Filter manual for further instructions and important safeguards. BETTA DIVIDER INSTALLATION: Included with MiniBow 2.5, Item# 17778 With foot facing downward, slide betta divider through slots on top frame down into slots on bottom of aquarium to secure in place. Divider will not fit properly if installed upside down. Optional divider should only be used for two bettas.
Aqueon Aquarium Mini-Bow 2.5 Gallon Acrylic Aquarium Kit
Size:
Dimensions: 7.75" L X 11.38" W X 14" H
Color: Black
Aquarium Size: 2.5 gallons