Super Pet MINI CritterTrail Two

Assembly InstructionsImportant: Carefully unpack and sort all components on the parts list. If you pet home experienced damage during shipping, please do not return your cage to the store. The Super Pet Customer Service Department is available to help with any problems. Please have your instructions with you when you call for fastest service.Toll-free number is 1-800-954-3003, Monday - Friday, 7:30 a.m. to 4:30 p.m. CST.Step 1: Place Food Dish in the BasePlace the base on a flat surface with the CritterTrail sticker facing you on the right hand side. Place the food dish in the right back corner by lowering the dish over the notch in the corner of the base until it slides into place.Step 2: Attach Side Passageways to BaseSlide the side passageways onto the base with the curved sides downward so the passageways rest in the grooves along the inside of the base. Firmly press down on the side clips to secure the side passageways to the base.Step 3: Insert Wire Panels Into BaseGently slide the wire panels down through the side grooves of the side passageways. Make sure that the vertical wires face the outside of the home and line up in the groove along the base.Step 4: Attach Exercise WheelInsert the wheel hub into the center hole of the exercise wheel. Attach the wheel to the center of the back wire panel between the fourth and fifth bar up from the bottom of the right hand side. Simply press the wheel hub all the way through the back wire panel and twist the hub half way to lock the wheel into place.Step 5: Roof AttachmentPlace the roof top on top of the assembled home with the door opening facing forward. Line up the grooves and gently press down until the roof top slides into place. Firmly press down on the side clips to secure the roof top to the side passageways.Step 6: Using the Water BottleTo fill the water bottle, remove the metal cap. Fill the bottle completely by placing it under a light stream of running water. Replace the metal cap and turn the water bottle upside down to allow a vacuum to form. You will experience a few initial drips while the vacuum forms. Hold the water bottle over the water bottle opening on roof top. Very gently slide the bottle in place. When refilling your water bottle, never squeeze it. This may cause a fracture in the plastic and make it impossible for the necessary vacuum to form.Hint: Accessory Access HolesThere are four access holes that will allow you unlimited expansion of your pet's home with the use of other CritterTrail Homes and Add-On Accessories. Three of the holes have been closed off for you using twist lock opening caps. The fourth location is open for placement of the water bottle. If you are ready to expand your pet's home, you can remove the twist lock opening cap by gently twisting it counter-clockwise. To replace the cap, carefully line up the tabs on the cap with the grooves in the opening and gently twist the cap clock-wise until it locks in place.Note: To expand upon an opened access hole on the roof top you will need to use a CritterTrail 10" Fun-nel Tube.Cleaning Your CritterTrail Mini TwoTo clean your CritterTrail Mini Two, simply pop up the clips securing the roof top to the side passageways and lift the roof top away from the home. If you like, you may also slide out the wire panels to easily reach into the base.When cleaning, do not use any abrasive or toxic cleaning products that may cause damage to your home or harm to your pet.After cleaning and replacing soiled bedding, replace roof top. Again, be sure to line up the grooves and gently press down until the roof top slides into place. Press down on the clips to secure the cage assembly.Made in China.